Initial Fluid Level Confirmation
WARNING: This page is about a different variant/trim than selected.
- Verify if transmission service has been performed.NOTE: Ensure the transmission has enough fluid in it to safely start the vehicle without damaging the transmission. With the vehicle off and the transmission fluid temperature at approximately 20 - 25°C (68 - 77°F), there must be at least enough fluid to drain out of the fluid level hole.
- If no transmission repair has been performed and no leaks are evident, proceed directly to the Final Level Checking Procedure below.
- Following any transmission service, remove the fluid filler cap (1) and the fluid level hole plug (2).
- If the fluid is flowing as a steady stream, wait until the fluid begins to drip.
- If no fluid comes out, add fluid until fluid drips out. Refer to Adhesives, Fluids, Lubricants and Sealers and Wire to Wire Repair - Engine Controls and Fuel
.NOTE: Service replacement transmissions may come shipped with up to 3L (3.2 Q) of fluid.
- Install the fluid level hole plug. Refer to Fastener Specifications (Off Vehicle) Fastener Specifications (On Vehicle) .
- Perform the Final Level Checking Procedure below.NOTE: You must confirm fluid level at the proper temperature range.