Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Vehicle ON.
- Verify that DTC P0721, P0723, P0776, P0777, P0966, P0967, P0969, P0970, P0971, P0973, P0974, P0976, P0977, P215C, P2720, P2721, P2728, P2729 or P2730 is not set.
- If the DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If the DTC is not set
- If the DTC is set
- Verify correct fluid level and condition by performing the Transmission Fluid Level and Condition Check .
- Verify correct oil pressure by performing the Line Pressure Check .
- Operate the vehicle in Dual Motors mode. The Clutch 2 Slip Speed parameter reading should be less than 200 RPM when the Clutch 2 Status parameter reading is Applied.
- If clutch slip speed is greater than 200 RPM
Refer to Component Testing.
- If clutch slip speed is less than 200 RPM
- If clutch slip speed is greater than 200 RPM
- All OK