Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Vehicle ON.
- Verify that DTC P0721, P0796, P0966, P0967, P0969, P0970, P0971, P0973, P0974, P0976, P0977, P215C, P2720, P2721, P2728, P2729 or P2730 is not set.
- If the DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If the DTC is not set
- If the DTC is set
- Perform the Transmission Fluid Level and Condition Check to verify correct fluid level and condition.
- Perform the Line Pressure Check to verify correct oil pressure.
- Operate and monitor the Clutch 1 Slip Speed parameter reading should be less than 200 RPM when the Clutch 1 Status parameter reading is Applied.
- If clutch slip speed is greater than 200 RPM
Refer to Component Testing.
- If clutch slip speed is less than 200 RPM
- If clutch slip speed is greater than 200 RPM
- All OK