Component Testing
WARNING: This page is about a different variant/trim than selected.
- Verify correct oil pressure by performing the Line Pressure Check .
- Perform the Control Solenoid Valve Performance Test .
- If a concern is found, replace the Q8 control solenoid valve.
- Inspect the valve body assembly for sticking or damaged valves. Refer Control Valve Body Diagnostic Inspection .
- If you found a stuck or damaged valve, repair or replace the valve or valve body.
- Inspect the variable low clutch for a stuck On or damaged condition.
- If you found a variable low clutch concern, repair or replace the variable low clutch assembly as necessary.