LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 5ET50 (MKE)) >> Diagnostic Information and Procedures >> DTC P079B: Transmission Clutch 2 Slip Detected >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Vehicle ON.
  2. Verify that DTC P0721, P077B-P077D or P215C is not set.
    • If the DTC is not set 
  3. Verify correct fluid level and condition by performing the Transmission Fluid Level and Condition Check .
  4. Verify correct oil pressure by performing the Line Pressure Check .
  5. Operate the vehicle up to 70 MPH (113 km/h). The Clutch 2 Slip Speed parameter reading should be less than 100 RPM when the Clutch 2 Status parameter reading is Applied.
    • If clutch slip speed is greater than 100 RPM 

      Refer to Component Testing.

    • If clutch slip speed is less than 100 RPM 
  6. All OK.
scientia non olet · About LEMON Manuals