Fastener Specifications
WARNING: This page is about a different variant/trim than selected.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.
|
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Auxiliary Battery Negative Cable to Engine Ground Stud (HP4) | 22 N.m (16 lb ft) |
| Auxiliary Battery Negative Cable Frame Ground Fastener (HP4) | 9 N.m (80 lb in) |
| Battery Hold Down Retainer Bolt (HP4) | 22 N.m (16 lb ft) |
| Battery Hold Down Retainer Nut (HP4) | 9 N.m (80 lb in) |
| Battery Negative Cable Clamp to Negative Battery Post Fastener (HP4) | 4.5 N.m (40 lb in) |
| Battery Negative Cable Ground Fastener (HP4) | 9 N.m (80 lb in) |
| Battery Positive Cable to APM Module (HP4) | 12 N.m (106 lb in) |
| Battery Positive Cable to Battery Pre-Fuse Block (HP4) | 16 N.m (12 lb ft) |
| Battery Positive Cable Clamp to Positive Battery Post Fastener (HP4) | 4.5 N.m (40 lb in) |
| Battery Tray Bolt | 22 N.m (16 lb ft) |
| Battery Tray Nut | 22 N.m (16 lb ft) |
| Body Harness Ground Fastener (HP4) | 9 N.m (80 lb in) |