LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 1.8L (LKN)) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Automatic Transmission Flex Plate (2) - Install
    Fig 1: Automatic Transmission Flex Plate Bolt
    GM4317938Courtesy of GENERAL MOTORS COMPANY
  2. Automatic Transmission Flex Plate Bolt (1) - Loosely install [8x]
    CAUTION: Refer to Fastener Caution .
    NOTE: Install NEW bolts.
  3. Install the EN-652  holder (2), lock the automatic transmission flex plate via the starter ring gear.
    Fig 2: Automatic Transmission Flex Plate Bolt
    GM4317933Courtesy of GENERAL MOTORS COMPANY
  4. Automatic Transmission Flex Plate Bolt (1) - Tighten in the sequence shown.
    Fig 3: Flex Plate Bolt Tightening Sequence
    GM2949005Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Torque-to-Yield Fastener Caution .

    Tighten

    1. First Pass: 30 N.m (22 lb ft)
    2. Final Pass: an additional 70 degrees using EN-45059 
  5. Remove the EN-652  holder.
  6. Transmission - Install Transmission Replacement
scientia non olet · About LEMON Manuals