Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief
- Remove the J-34730-1A gauge (1).
- Disconnect the quick connect couplings of the CH-37287-1A adapter (2) from the fuel feed hose and from the fuel feed pipe on the fuel pump. Use a shop towel in order to catch any remaining fuel that may leak. Refer to Metal Collar Quick Connect Fitting Service
- Connect the quick-connect fitting of the fuel feed hose to the fuel feed pipe of the fuel pump.
- Turn ON the ignition in order to pressurize the fuel system.
- Turn OFF the ignition.
- Check for any fuel leaks.
- Intake Manifold Cover - Install Intake Manifold Cover Replacement