LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 1.8L (LKN) - Repair Instructions) >> Repair Instructions >> Fuel Injection Pump Sound Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the fuel injection pump sound insulator (1).
    Fig 1: Fuel Injection Pump Sound Insulator
    GM4859594Courtesy of GENERAL MOTORS COMPANY
  2. Connect the electrical connector (1).
    Fig 2: Electrical Connector
    GM4859593Courtesy of GENERAL MOTORS COMPANY
  3. Connect the evaporative emission front pipe to the evaporative emission canister purge solenoid valve and fuel feed evaporative emission separator pipe clip. Refer to Evaporative Emission Front Pipe Replacement 
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
scientia non olet · About LEMON Manuals