Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Intake Manifold Cover - Remove Intake Manifold Cover Replacement
Exhaust Gas Recirculation Cooler Temperature Sensor - Position 1 - Remove Exhaust Gas Recirculation Cooler Temperature Sensor Replacement - Position 1

Fig 1: Exhaust Gas Recirculation Cooler Temperature Sensor - Position 1
Courtesy of GENERAL MOTORS COMPANY
Exhaust Gas Recirculation Cooler Temperature Sensor Bracket - Remove Exhaust Gas Recirculation Cooler Temperature Sensor Bracket Replacement
Catalytic Converter Heat Shield - Remove Catalytic Converter Heat Shield Replacement (LKN)

Fig 2: Catalytic Converter Heat Shield Nut
Courtesy of GENERAL MOTORS COMPANY
Exhaust Gas Recirculation Cooler Outlet Pipe - To Fuel Heater Return Hose - Remove Exhaust Gas Recirculation Cooler Outlet Pipe Replacement (To Fuel Heater Return Hose) Exhaust Gas Recirculation Cooler Outlet Pipe Replacement (To Intake Manifold)
Exhaust Gas Recirculation Cooler Inlet Pipe - Remove Exhaust Gas Recirculation Cooler Inlet Pipe Replacement
Electrical Connector (1) - Disconnect

Fig 3: Electrical Connector
Courtesy of GENERAL MOTORS COMPANY
Retainer (2) - Unclip
Exhaust Gas Recirculation Cooler Bolt (1) - Remove [2x]

Fig 4: Exhaust Gas Recirculation Cooler Bolt
Courtesy of GENERAL MOTORS COMPANY
Exhaust Gas Recirculation Pipe Bolt (2) - Remove [2x]
Exhaust Gas Recirculation Valve Inlet Bolt (1) - Remove [3x]

Fig 5: Exhaust Gas Recirculation Valve Inlet Bolt
Courtesy of GENERAL MOTORS COMPANY
Exhaust Gas Recirculation Cooler (1) - Remove

Fig 6: Exhaust Gas Recirculation Cooler
Courtesy of GENERAL MOTORS COMPANY
Exhaust Gas Recirculation Valve Inlet Gasket (2) - Remove
NOTE: The gasket is reusable, inspect the gasket and replace if damaged.
Exhaust Gas Recirculation Pipe Gasket (3) - Remove
NOTE: The gasket is reusable, inspect the gasket and replace if damaged.