Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Camshaft Position Sensor (2) - Install

Fig 1: Camshaft Position Sensor Bolt
Courtesy of GENERAL MOTORS COMPANY
Camshaft Position Sensor Bolt (1) - Install and tighten 10 N.m (89 lb in)
WARNING: Refer to Fastener Caution .
Engine Wiring Harness Bracket (2) - Install

Fig 2: Engine Wiring Harness Bracket Nut
Courtesy of GENERAL MOTORS COMPANY
Engine Wiring Harness Bracket Nut (1) - Install and tighten [2x] 9 N.m (80 lb in)
Camshaft Position Sensor Electrical Connector (2) - Connect

Fig 3: Retainer
Courtesy of GENERAL MOTORS COMPANY
Retainer (1) - Install
Intake Manifold Cover - Install Intake Manifold Cover Replacement