Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Camshaft Position Sensor (2) - Install
- Camshaft Position Sensor Bolt (1) - Install and tighten 10 N.m (89 lb in)WARNING: Refer to Fastener Caution .
- Electrical Connector (1) @ Camshaft Position Sensor (2) - Connect
- Install the transmission range selector lever cable (2) to the cable bracket.
WARNING: After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
- Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
- Adjust the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Adjustment
- Intake Manifold Cover - Install Intake Manifold Cover Replacement