Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Intake Manifold Cover - Remove Intake Manifold Cover Replacement
Electrical Connector (1) @ Camshaft Position Actuator Solenoid Valve (2) - Disconnect

Fig 1: Camshaft Position Actuator Solenoid Valve
Courtesy of GENERAL MOTORS COMPANY
Camshaft Position Actuator Solenoid Valve Bolt (1) - Remove

Fig 2: Camshaft Position Actuator Solenoid Valve Bolt
Courtesy of GENERAL MOTORS COMPANY
Camshaft Position Actuator Solenoid Valve (2) - Remove
NOTE: Inspect the camshaft position actuator solenoid valve o-ring and replace as necessary.