Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Disable the high voltage system. Refer to High Voltage Disabling
High Voltage Battery (1) - Remove High Voltage Battery Replacement and Shipping Preparation

Fig 1: High Voltage Battery
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Left Side (1) - Remove High Voltage Battery Tray Reinforcement Replacement (Left Side)

Fig 2: High Voltage Battery Tray Reinforcement -- Left Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Right Side (1) - Remove - High Voltage Battery Tray Reinforcement Replacement (Right Side)

Fig 3: High Voltage Battery Tray Reinforcement -- Right Side
Courtesy of GENERAL MOTORS COMPANY
Slide the cell battery vent tube grommet (2) off the battery hold down retainer side panel.

Fig 4: Cell Battery Vent Tube Grommet
Courtesy of GENERAL MOTORS COMPANY
Release the cell battery vent tube from the retainer clips (1).
Disengage the cell battery vent tube from each cell battery module.
Cell Battery Vent Tube (3) - Remove