Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Slide the cell battery vent tube grommet (2) onto the battery hold down retainer side panel.

Fig 1: Cell Battery Vent Tube Grommet
Courtesy of GENERAL MOTORS COMPANY
Engage the battery vent tube onto the retainer clips (1).
Install the cell battery vent tube onto each cell battery module.
High Voltage Battery Tray Reinforcement - Right Side (1) - Install High Voltage Battery Tray Reinforcement Replacement (Right Side)

Fig 2: High Voltage Battery Tray Reinforcement -- Right Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Left Side (1) - Install High Voltage Battery Tray Reinforcement Replacement (Left Side)

Fig 3: High Voltage Battery Tray Reinforcement -- Left Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery (1) - Install High Voltage Battery Replacement and Shipping Preparation

Fig 4: High Voltage Battery
Courtesy of GENERAL MOTORS COMPANY
Enable the high voltage system. Refer to High Voltage Enabling