Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Disable the high voltage system. Refer to High Voltage Disabling
High Voltage Battery (1) - Remove High Voltage Battery Replacement and Shipping Preparation

Fig 1: High Voltage Battery
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Left Side (1) - Remove High Voltage Battery Tray Reinforcement Replacement (Left Side)

Fig 2: High Voltage Battery Tray Reinforcement -- Left Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Right Side (1) - Remove High Voltage Battery Tray Reinforcement Replacement (Right Side)

Fig 3: High Voltage Battery Tray Reinforcement -- Right Side
Courtesy of GENERAL MOTORS COMPANY
Battery Cover - Front (3) - Remove Battery Cover Replacement (Front Panel)

Fig 4: Battery Cover -- Front
Courtesy of GENERAL MOTORS COMPANY
Battery Cover - Back (2) - Remove Battery Cover Replacement (Back Panel)

Fig 5: Battery Cover -- Back
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer - Right Side Panel (3) - Remove Battery Hold Down Retainer Replacement (Right Side Panel)

Fig 6: Wiring Harness Retainer
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer - Left Side Panel (3) - Remove Battery Hold Down Retainer Replacement (Left Side Panel)

Fig 7: Battery Hold Down Retainer -- Left Side Panel
Courtesy of GENERAL MOTORS COMPANY
Battery Cooling Air Inlet Duct - Front (2) - Remove

Fig 8: Battery Cooling Air Inlet Duct -- Front
Courtesy of GENERAL MOTORS COMPANY

NOTE: Take care not to damage duct seal (1) when removing.
Battery Cooling Air Inlet Duct - Rear (1) - Remove

Fig 9: Battery Cooling Air Inlet Duct -- Rear
Courtesy of GENERAL MOTORS COMPANY

NOTE: Take care not to damage duct seal (2), when removing.
High Voltage Bus Bar Fastener (1) - Remove [4x]

Fig 10: High Voltage Bus Bar
Courtesy of GENERAL MOTORS COMPANY
High Voltage Bus Bar (2) - Remove [2x]
Disconnect the ribbon connector. (1)

Fig 11: Ribbon Connector
Courtesy of GENERAL MOTORS COMPANY
Battery Vent Tube (2) - Disconnect

Fig 12: Battery Vent Tube
Courtesy of GENERAL MOTORS COMPANY
Electrical Connector (1) - Disconnect [2x]
Retainer Clip (3) - Disengage
High Voltage Battery Interface Control Module (1) - Remove

Fig 13: High Voltage Battery Interface Control Module
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Bolt (2) - Remove [4x]

Fig 14: Battery Hold Down Retainer
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer (1) - Remove [2x]
Cell Battery Module (1) - Remove

Fig 15: Cell Battery Module
Courtesy of GENERAL MOTORS COMPANY

NOTE: If a service replacement cell battery module is required, the replacement cell battery module will need to have its cell voltages balanced. In order to facilitate installing EL-50332 cell balancing service tool, the replacement cell battery module will have to go in cell battery module 4 or cell battery module 5 location. Repositioning the existing cell battery module 4 or cell battery module 5 into the location of the cell battery module requiring replacement as applicable.
If replacing the cell battery module, insert the shipping bracket (2) that comes with the NEW cell battery.

Fig 16: Shipping Bracket
Courtesy of GENERAL MOTORS COMPANY
Install the retainers. (1)