Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Disable the high voltage system. Refer to High Voltage Disabling
High Voltage Battery (1) - Remove High Voltage Battery Replacement and Shipping Preparation

Fig 1: High Voltage Battery
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Left Side (1) - Remove High Voltage Battery Tray Reinforcement Replacement (Left Side)

Fig 2: High Voltage Battery Tray Reinforcement -- Left Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Right Side (1) - Remove High Voltage Battery Tray Reinforcement Replacement (Right Side)

Fig 3: High Voltage Battery Tray Reinforcement -- Right Side
Courtesy of GENERAL MOTORS COMPANY
Battery Cover - Front (3) - Remove Battery Cover Replacement (Front Panel)

Fig 4: Battery Cover -- Front
Courtesy of GENERAL MOTORS COMPANY
Battery Cover - Back (2) - Remove Battery Cover Replacement (Back Panel)

Fig 5: Battery Cover -- Back
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer - Right Side Panel (3) - Remove - Battery Hold Down Retainer Replacement (Right Side Panel)

Fig 6: Wiring Harness Retainer
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer - Left Side Panel (3) - Remove Battery Hold Down Retainer Replacement (Left Side Panel)

Fig 7: Battery Hold Down Retainer -- Left Side Panel
Courtesy of GENERAL MOTORS COMPANY
Battery Cooling Air Inlet Duct - Front (2) - Remove

Fig 8: Battery Cooling Air Inlet Duct -- Front
Courtesy of GENERAL MOTORS COMPANY

NOTE: Take care not to damage duct seal (1) when removing.
Battery Cooling Air Inlet Duct - Rear (1) - Remove

Fig 9: Battery Cooling Air Inlet Duct -- Rear
Courtesy of GENERAL MOTORS COMPANY

NOTE: Take care not to damage duct seal (2), when removing.
High Voltage Bus Bar Fastener (1) - Remove [2x]

Fig 10: High Voltage Bus Bar Fastener
Courtesy of GENERAL MOTORS COMPANY
High Voltage Bus Bar (2) - Remove
Disconnect the ribbon connector. (1)

Fig 11: Ribbon Connector
Courtesy of GENERAL MOTORS COMPANY
Battery Vent Tube - (2) Disconnect

Fig 12: Battery Vent Tube
Courtesy of GENERAL MOTORS COMPANY
Electrical Connector (1) - Disconnect
Retainer Clip (3) - Disengage
High Voltage Battery Interface Control Module (1) - Remove

Fig 13: High Voltage Battery Interface Control Module
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Bolt (2) - Remove [2x]

Fig 14: Battery Hold Down Retainer
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer (1) - Remove
Cell Battery Module (1) - Remove

Fig 15: Cell Battery Module
Courtesy of GENERAL MOTORS COMPANY
If replacing the cell battery module, insert the shipping bracket (2) that comes with the NEW cell battery.

Fig 16: Shipping Bracket
Courtesy of GENERAL MOTORS COMPANY
Install the retainers. (1)