Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Battery Hold Down Retainer - Right Side Panel (3) - Install

Fig 1: Wiring Harness Retainer
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer Nut (1) - Install and tighten [4x] 9 N.m (80 lb in)
CAUTION: Refer to Fastener Caution
Wiring Harness Retainer (2) - Engage
Battery Cover - Front (3) - Install Battery Cover Replacement (Front Panel)

Fig 2: Battery Cover -- Front
Courtesy of GENERAL MOTORS COMPANY
Battery Cover - Back (2) - Install Battery Cover Replacement (Back Panel)

Fig 3: Battery Cover -- Back
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Right Side (1) - Install High Voltage Battery Tray Reinforcement Replacement (Right Side)

Fig 4: High Voltage Battery Tray Reinforcement -- Right Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Left Side (1) - Install High Voltage Battery Tray Reinforcement Replacement (Left Side)

Fig 5: High Voltage Battery Tray Reinforcement -- Left Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery (1) - Install High Voltage Battery Replacement and Shipping Preparation

Fig 6: High Voltage Battery
Courtesy of GENERAL MOTORS COMPANY
Enable the high voltage system. Refer to High Voltage Enabling