Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Battery Cooling Air Inlet Duct - Rear (1) - Install

Fig 1: Battery Cooling Air Inlet Duct -- Rear
Courtesy of GENERAL MOTORS COMPANY

NOTE: Take care not to damage duct seal (2), when installing.
Battery Hold Down Retainer - Left Side Panel (3) - Install

Fig 2: Battery Hold Down Retainer -- Left Side Panel
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer Nut (1) - Install and tighten [4x] 9 N.m (80 lb in)
CAUTION: Refer to Fastener Caution
Install the cell battery vent tube grommet (2) to the top of the battery hold down retainer.
Battery Hold Down Retainer - Right Side Panel (3) - Install

Fig 3: Wiring Harness Retainer
Courtesy of GENERAL MOTORS COMPANY
Battery Hold Down Retainer Nut (1) - Install and tighten [4x] 9 N.m (80 lb in)
Wiring Harness Retainer (2) - Engage
Battery Cover - Front (3) - Install Battery Cover Replacement (Front Panel)

Fig 4: Battery Cover -- Front
Courtesy of GENERAL MOTORS COMPANY
Battery Cover - Back (2) - Install Battery Cover Replacement (Back Panel)

Fig 5: Battery Cover -- Back
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Right Side (1) - Install High Voltage Battery Tray Reinforcement Replacement (Right Side)

Fig 6: High Voltage Battery Tray Reinforcement -- Right Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery Tray Reinforcement - Left Side (1) - Install High Voltage Battery Tray Reinforcement Replacement (Left Side)

Fig 7: High Voltage Battery Tray Reinforcement -- Left Side
Courtesy of GENERAL MOTORS COMPANY
High Voltage Battery (1) - Install High Voltage Battery Replacement and Shipping Preparation

Fig 8: High Voltage Battery
Courtesy of GENERAL MOTORS COMPANY
Enable the high voltage system. Refer to High Voltage Enabling