LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (Left Side) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the left transmission mount (5) to the vehicle.
    Fig 1: Transmission Mount
    GM4507711Courtesy of GENERAL MOTORS COMPANY
    NOTE: Engine Control Module Bracket removed for clarity.
  2. Transmission Mount Bolt (4)» Install [2x] 100 N.m (74 lb ft)
    CAUTION: Refer to Fastener Caution .
  3. Transmission Mount Transmission Side Bolt» Install and tighten [4x]
    1. First Pass: 100 N.m (74 lb ft)
    2. Final Pass: 60-75 Degrees
  4. Position the transmission mount bracket (2) to the vehicle.
  5. Engine Mount Brace Bolt (1)» Install [2x] 22 N.m (16 lb ft).
  6. Remove the transmission jack.
  7. Install the Engine Wiring Harness Fuse Block Bracket. Refer to Engine Wiring Harness Fuse Block Bracket Replacement
  8. Install the battery tray. Refer to Battery Tray Replacement
scientia non olet · About LEMON Manuals