LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Drain and Fill >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lower the vehicle.
    Fig 1: Fluid Fill Cap
    GM4486476Courtesy of GENERAL MOTORS COMPANY
  2. Remove the engine control module bracket. Refer to Engine Control Module Bracket Replacement
  3. Remove the fluid fill cap (1), if accessible.
    NOTE: If the transmission fluid filler cap cannot be accessed, proceed to the next step in this procedure.
  4. Remove the left front wheel and tire assembly. Refer to Tire and Wheel Removal and Installation
  5. Remove the fluid filler plug (1) from the transmission.
    Fig 2: Fluid Filler Plug
    GM4487151Courtesy of GENERAL MOTORS COMPANY
  6. Fill the transmission to the proper level with the correct fluid. Refer to Transmission Fluid Level and Condition Check and Adhesives, Fluids, Lubricants and Sealers .
  7. Install the fluid fill cap (1), if accessible.
    Fig 3: Fluid Fill Cap
    GM4486476Courtesy of GENERAL MOTORS COMPANY
  8. Install the engine control module bracket. Refer to Engine Control Module Bracket Replacement
  9. Install the fluid filler plug (1) to the transmission and tighten to 40 N.m (30 lb ft).
    Fig 4: Fluid Filler Plug
    GM4487151Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Component Fastener Tightening Caution .
  10. Install the left front wheel and tire assembly. Refer to Tire and Wheel Removal and Installation
scientia non olet · About LEMON Manuals