LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the input speed sensor seal (3).
    Fig 1: Input Speed Sensor Bolt
    GM4487717Courtesy of GENERAL MOTORS COMPANY
  2. Install the input speed sensor (2).
  3. Install the input speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
    CAUTION: Refer to Fastener Caution .
  4. Install the left front wheel house liner. Refer to Front Wheelhouse Liner Replacement .
  5. Perform the solenoid valve characterization procedure. Refer to Solenoid Valve Characterization Reprogramming .
scientia non olet · About LEMON Manuals