Fuel Feed Intermediate Pipe Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Fuel Feed Intermediate Pipe

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Gasoline/Gasoline Vapors Warning . Preliminary Procedures Fuel Pressure Relief Fuel Pump Cover Replacement
1	Fuel Feed Intermediate Pipe Fitting [2x] CAUTION: Refer to Component Fastener Tightening Caution . Procedure Hand start the NEW fuel feed intermediate pipe fittings. Tighten Tighten the fitting nut to the fuel rail to 15 N.m (11 lb ft) Tighten the fitting nut to the fuel pump to 15 N.m (11 lb ft) Tighten the fitting nut to the fuel rail a final pass to 30 N.m (22 lb ft) Tighten the fitting nut to the fuel pump a final pass to 30 N.m (22 lb ft)
2	Fuel Feed Intermediate Pipe NOTE: The fuel feed intermediate pipe is a one time use component, do NOT re-use.

Callout

Component Name

WARNING: Refer to Gasoline/Gasoline Vapors Warning .

Preliminary Procedures

Fuel Pressure Relief
Fuel Pump Cover Replacement

Fuel Feed Intermediate Pipe Fitting [2x]

CAUTION: Refer to Component Fastener Tightening Caution .

Procedure
Hand start the NEW fuel feed intermediate pipe fittings.
Tighten
Tighten the fitting nut to the fuel rail to 15 N.m (11 lb ft)
Tighten the fitting nut to the fuel pump to 15 N.m (11 lb ft)
Tighten the fitting nut to the fuel rail a final pass to 30 N.m (22 lb ft)
Tighten the fitting nut to the fuel pump a final pass to 30 N.m (22 lb ft)

Fuel Feed Intermediate Pipe

NOTE: The fuel feed intermediate pipe is a one time use component, do NOT re-use.