LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lower Oil Pan Replacement  - Remove
  2. Disconnect the oil level sensor electrical connector (1).
    Fig 1: Oil Level Sensor Electrical Connector And Fasteners
    GM4244683Courtesy of GENERAL MOTORS COMPANY
  3. Remove the engine oil level sensor fasteners (2).
  4. Remove the engine oil level sensor C-clip (1).
    Fig 2: Engine Oil Level Sensor Connector And C-Clip
    GM4244692Courtesy of GENERAL MOTORS COMPANY
  5. Push the sensor connector (2) through the oil pan to remove.
  6. Remove the engine oil level sensor (1) from the oil pan.
    Fig 3: Engine Oil Level Sensor And O-Ring
    GM4244703Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals