Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Ignition Coil Replacement - Remove
- Vacuum Pump Replacement - Remove
- Positive Crankcase Ventilation Tube @ Air Cleaner Outlet Duct - Disconnect Plastic Collar Quick Connect Fitting Service »
- Turbocharger Heat Shield Replacement - Remove
- Positive Crankcase Ventilation Hose Fitting Bolt (1) - Remove
NOTE: The PCV hose and fitting assembly (2) is a permanent connection. Reinstall these components as an assembly unless new components are being used.NOTE: Always ensure the PCV hose fitting O-Ring (3) seal is free of cuts or abrasions each time the fitting is attached to the turbocharger.
- Positive Crankcase Ventilation Hose Fitting (2) - Disconnect
- Turbocharger Coolant Return Pipe Replacement (LTG) - Remove
- Oil Level Indicator - Remove
- Engine Coolant Air Bleed Pipe Replacement (LTG) - Remove
- Camshaft Position Actuator Intake Solenoid Valve Replacement - Remove
- Camshaft Position Actuator Exhaust Solenoid Valve Replacement - Remove
- Camshaft Cover Heat Shield Replacement - Remove
- Camshaft Cover Bolt (1, 2) - Remove
NOTE: Note the location of the four long camshaft cover bolts (2) for proper installation.
- Camshaft Cover (3) - Remove
- Camshaft Cover Gasket (1) - Remove and DISCARD
- If reinstalling the camshaft cover (2), clean and inspect as needed. Refer to Camshaft Cover Cleaning and Inspection