Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify that no other hybrid/EV powertrain or motor control module DTC is set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
- If any of the DTCs are set
- Verify the transmission fluid level and condition is correct and inspect for other causes of transmission overheating. Refer to Transmission Fluid Level and Condition Check
and Transmission Overheats (AF50-8)Transmission Overheats (5ET50)
.NOTE: Fluid level that is either too high or too low can result in overheating.
- If a condition was found
Repair as necessary.
- If a condition was not found
- If a condition was found
- Verify DTC P2797 is not set.
- If the DTC is set
- Verify the T6 Power Inverter Module has the latest calibration in Calibration Information.
- If the T6 Power Inverter Module does not have the latest calibration, program the T6 power inverter module.
- If the T6 Power Inverter Module has the latest calibration, replace the T6 Power Inverter Module.
- Verify the DTC does not set.
- If the DTC sets.
- Replace the G5 Transmission Fluid Pump - Electric/Auxiliary.
- Verify the DTC does not set.
- If the DTC sets, replace the T6 Power Inverter Module.
- If the DTC is not set
- All OK.