Circuit/System Verification
- Ignition ON, perform the Gauge Sweep test. Refer to Engineering Mode Description and Operation . Verify that the tachometer gauge sweeps to approximately 1800 rpm and then returns to zero.
- If the tachometer does not sweep properly
Replace the P16 Instrument Cluster.
- Go to next step: If the tachometer sweeps properly
- If the tachometer does not sweep properly
- Drive the vehicle, verify the tachometer matches the values on the scan tool.
- If the values do not match
Replace the P16 Instrument Cluster.
- Go to next step: If the values match the scan tool
- If the values do not match
- All OK.