Rear Seat Riser Latch Replacement (60/40 Bench)

Fig 1: Rear Seat Riser Latch And Components (60/40 Bench)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the rear seat. Refer to Rear Seat Removal and Installation (60/40 Bench) . NOTE: Service sides individually as required.
1	Rear Seat Riser Finish Cover Fastener
2	Rear Seat Riser Opening Finish Cover Procedure Remove the rear seat riser opening finish cover. Refer to Rear Seat Riser Opening Finish Cover Replacement .
3	Rear Seat Riser Finish Cover Procedure Remove the rear seat riser finish cover. Refer to Rear Seat Riser Finish Cover Replacement . Remove the rear seat cushion trim panel. Refer to Rear Seat Cushion Trim Panel Replacement (60/40 Bench) .
4	Rear Seat Riser Bolt (Qty: 2) Tighten 9 N.m (80 lb in)
5	Rear Seat Riser Procedure Disconnect the seat riser strut from the seat riser. Disconnect the harness retainers and the connector from the seat riser. Lift the seats off the riser assembly.
6	Rear Seat Riser Latch