Front Bumper Fascia Replacement

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front compartment front sight shield. Refer to Front Compartment Front Sight Shield Replacement . Remove the front bumper fascia air deflector. Refer to Front Bumper Fascia Air Deflector Replacement . Remove the front right hand and left hand wheelhouse liners. Refer to Front Wheelhouse Liner Replacement - Right Side , Front Wheelhouse Liner Replacement - Left Side .
1	Front Bumper Fascia Bracket bolt (Qty: 2) CAUTION: Refer to Fastener Caution .
2	Front Bumper Fascia Lower Push-In Retainers (Qty: 4)
3	Front Bumper Fascia Upper Push-In Retainers (Qty: 6)
4	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the front fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide. Disconnect any electrical connectors. Transfer components as necessary.
5	Forward Lamp Harness Procedure Before installing the front bumper fascia make sure that the forward lamp harness is taped up at the location shown above (arrows). This will prevent any noise coming from the front bumper lower shutter.