Camshaft Position Actuator Intake Solenoid Valve Replacement

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Actuator Intake Solenoid Valve

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (LKW) and Intake Manifold Cover Replacement (LTG) .
1	Camshaft Position Actuator Intake Solenoid Valve Fastener CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Actuator Intake Solenoid Valve Procedure Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve. Install a NEW seal if not replacing the solenoid valve.

Callout

Component Name

Preliminary Procedure
Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (LKW) and Intake Manifold Cover Replacement (LTG) .

Camshaft Position Actuator Intake Solenoid Valve Fastener

CAUTION: Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Position Actuator Intake Solenoid Valve

Procedure

Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve.
Install a NEW seal if not replacing the solenoid valve.