Turbocharger Coolant Return Pipe Replacement

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turbocharger Coolant Return Pipe

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716) and Cooling System Draining and Filling (Static) . Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (LKW) and Intake Manifold Cover Replacement (LTG) . Remove the turbocharger heat shield. Refer to Turbocharger Heat Shield Replacement . NOTE: Replace hose clamp if necessary. Special Tools BO-38185 Hose Clamp PliersFor equivalent regional tools, refer to Special Tools .
1	Engine Coolant Air Bleed Hose
2	Turbocharger Coolant Return Pipe Fastener CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
3	Turbocharger Coolant Return Pipe Bolt Tighten 35 N.m (26 lb ft)
4	Turbocharger Coolant Return Pipe Washer (Qty: 2) NOTE: Install 2 NEW washers.
5	Turbocharger Coolant Return Pipe