LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Cooling System >> Repair Instructions >> Transmission Fluid Auxiliary Cooler Replacement >> Installation Procedure

Installation Procedure

  1. Install transmission fluid auxiliary cooler (2).
    Fig 1: Automatic Transmission Fluid Auxiliary Cooler
    GM2192377Courtesy of GENERAL MOTORS COMPANY
  2. Install transmission fluid auxiliary cooler pipe bolt (5) and tighten to 4 N.m (35 lb in).
    CAUTION: Refer to Fastener Caution .
  3. Attach transmission fluid cooler intermediate pipe (4) and fluid cooler outlet pipe (3) to transmission fluid auxiliary cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection (6T30-MH9 and 6T40-MH8)  and Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection (AF40-MDK) .
  4. Install radiator air seal (1).
  5. Install the fluid level drain plug (1) and tighten to 12 N.m (106 lb in).
    Fig 2: Identifying Fluid Level Hole Plug
    GM1998836Courtesy of GENERAL MOTORS COMPANY
  6. Top up transmission fluid and check transmission fluid level. Refer to Transmission Fluid Drain and Fill , Approximate Fluid Capacities (6T40/45/50) and Approximate Fluid Capacities (6T30) .
  7. Install the radiator grille reinforcement support. Refer to Front Grille Support Replacement .
scientia non olet · About LEMON Manuals