LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System - Manual >> Repair Instructions >> Mode Valve Gear Replacement >> Installation Procedure

Installation Procedure

  1. Install 2 mode valve gear (1).
    Fig 1: Mode Valve Gear
    GM2027967Courtesy of GENERAL MOTORS COMPANY
  2. Make sure that mode valve gears of mode valve levers (1) are fitted as shown in graphic above.
    Fig 2: Mode Valve Levers
    GM2027978Courtesy of GENERAL MOTORS COMPANY
    NOTE: The mode valve gear can only be fitted in one position. The mode valve gears have to be fitted to the according mode valve levers in figured position. The ventilation dampers have to be in middle position.
  3. Install mode control cam (1).
    Fig 3: Mode Control Cam
    GM2027962Courtesy of GENERAL MOTORS COMPANY
    NOTE: The mode control cam can only be fitted in one position.
  4. Install instrument panel tie bar (2).
    Fig 4: Instrument Panel Tie Bar, Bolts And Nuts
    GM2027821Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    • Install 4 instrument panel tie bar bolts (3, 4) and tighten to 22 N.m (17 lb ft).
    • Install 2 instrument panel tie bar nuts (1) and tighten to 9 N.m (80 lb in).
  5. Install instrument panel wiring harness (2) from instrument panel tie bar (1).
    Fig 5: Instrument Panel Wiring Harness And Instrument Panel Tie Bar
    GM2027818Courtesy of GENERAL MOTORS COMPANY

    Connect electrical connectors.

  6. Install instrument panel assembly. Refer to Instrument Panel Assembly Replacement .
scientia non olet · About LEMON Manuals