Installation Procedure

Install air inlet valve and inside air valve control cam (1).

Fig 1: Inside Air Valve Control Cam
Courtesy of GENERAL MOTORS COMPANY

NOTE: The air inlet valve and inside air valve control cam can only be fitted in one position.
Install mode control cam actuator (1) and install 3 mode control cam actuator screws (2) and connect electrical connector. Tighten to 2.5 N.m (23 lb in).

Fig 2: Mode Control Cam Actuator
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Install instrument panel compartment assembly. Refer to Instrument Panel Compartment Replacement .