Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the mass airflow sensor/intake air temperature sensor wiring harness plug (2).
- Unclip the engine control module (ECM) wiring harness (3) from the air cleaner housing.
- Remove the air cleaner outlet duct (1). Refer to Air Cleaner Outlet Duct Replacement .
- Remove the secondary air injection pump inlet hose (4) from the air cleaner upper housing.
- Remove the mass airflow sensor (3) from the air cleaner upper housing (2). Refer to Mass Airflow Sensor Replacement .
- Remove the 6 air cleaner housing cover bolts (1).
- Remove the air cleaner upper housing (2).