LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Oil Pan Replacement (Manual Transmission) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Open the hood.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Place collecting basin underneath.
  4. Remove the oil drain bolt.
  5. Collect the engine oil.
  6. Install the NEW seal ring and the oil drain bolt, tighten to 14 N.m (124 lb in).
    CAUTION: Refer to Fastener Caution .
  7. Lower the vehicle.
  8. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  9. Raise the vehicle.
  10. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  11. Remove the engine oil heater. Refer to Engine Oil Heater Replacement .
  12. Remove the exhaust front pipe. Refer to Exhaust Front Pipe Replacement .
  13. Remove the 3 oil pan bolts (1, 2) from the transmission.
    Fig 1: Oil Pan Bolts
    GM2027007Courtesy of GENERAL MOTORS COMPANY
  14. Remove the 15 oil pan bolts (1) and remove the oil pan (2).
    Fig 2: Oil Pan And Bolts
    GM2027008Courtesy of GENERAL MOTORS COMPANY
    NOTE: Remove the oil pan evenly all the way around with a suitable tool.
  15. To prevent damage to the oil screen, ensure that the oil screen (2) remains in the oil pan (3). If the oil screen gets caught on the cylinder block (1), push it into the oil pan.
    Fig 3: Cylinder Block, Engine Oil Pan And Oil Screen
    GM2028080Courtesy of GENERAL MOTORS COMPANY
    NOTE: Use a screwdriver or another suitable tool.
  16. Remove the oil pan.
scientia non olet · About LEMON Manuals