LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Engine Front Cover with Oil Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Open the hood.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement (1.8L LUW and LWE) .
  4. Drain the cooling system. Refer to Cooling System Draining and Filling (GE-47716 Fill) and Cooling System Draining and Filling (Static Fill) .
  5. Remove the air conditioning compressor. Refer to Air Conditioning Compressor Replacement (1.8L LUW and LWE) .
  6. Remove the generator. Refer to Generator Replacement (1.8L LUW and LWE) .
  7. Remove the timing belt rear cover. Refer to Timing Belt Rear Cover Replacement .
  8. Remove the oil pan. Refer to Oil Pan Replacement (Manual Transmission)  and Oil Pan Replacement (Automatic Transmission) .
  9. Remove the radiator outlet hose from the water pump. Refer to Radiator Outlet Hose Replacement (1.8L LUW and LWE) .
  10. Remove the engine oil cooler inlet pipe bolt (4).
    Fig 1: Engine Oil Cooler Outlet Pipe And Bolts
    GM2027690Courtesy of GENERAL MOTORS COMPANY
  11. Push the engine oil cooler inlet pipe (1) into the engine oil cooler housing (2).
  12. Remove the 2 engine oil cooler outlet pipe bolts (5) from the water pump.
  13. Push the engine oil cooler outlet pipe (3) into the engine oil cooler housing (2).
  14. Remove the 8 engine front cover bolts (2, 3).
    Fig 2: Engine Front Cover, Seal And Bolts
    GM2027688Courtesy of GENERAL MOTORS COMPANY
  15. Remove the engine front cover (4).
  16. Remove the engine front cover seal (1).