Ignition Coil Installation

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-6009 Remover/Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

Install the ignition coil module (2) with the EN-6009 remover/installer (1).

Fig 1: Ignition Coil Module And Special Tool
Courtesy of GENERAL MOTORS COMPANY
Remove the EN-6009 remover/installer (1).
Install the 2 ignition coil bolts and tighten to 8 N.m (71 lb in).
CAUTION: Refer to Fastener Caution

NOTE: Note the arrow on the cover.
Install the cover of the DIS ignition coil against the direction of the arrow.
NOTE: Note the arrow on the cover.