Crankshaft Front Oil Seal Removal

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-45000 Remover

For equivalent regional tools, refer to Special Tools .

Fig 1: Crankshaft Front Oil Seal Removal Tool

Courtesy of GENERAL MOTORS COMPANY

CAUTION: Clean the crankshaft sealing surface with a clean, lint-free towel. Inspect lead-in edge of crankshaft for burrs/sharp edges that could damage the rear main oil seal. Remove burrs/sharp edges with crocus cloth before proceeding.

Using the EN-45000 remover (3), remove the crankshaft front oil seal (1) from the crankshaft (2).