Crankshaft Balancer Removal

Special Tools 

EN-652  Flywheel Holder

For equivalent regional tools, refer to Special Tools .

1. Install the EN-652  holder (1). Lock the flywheel (2) or the automatic transmission flex plate via the starter ring gear.
   Fig 1: Flywheel And Flywheel Holder

   Courtesy of GENERAL MOTORS COMPANY
2. Remove and DISCARD the crankshaft balancer bolt (4).
   Fig 2: Crankshaft Balancer, Washer And Bolt

   Courtesy of GENERAL MOTORS COMPANY
3. Remove the crankshaft balancer washer (3).
4. Remove the crankshaft balancer (2).