Automatic Transmission Flex Plate Removal

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-652 Automatic Transmission Flex Plate Holder

For equivalent regional tools, refer to Special Tools .

Install the EN-652 holder (1) to hold the automatic transmission flex plate (2).

Fig 1: Automatic Transmission Flex Plate And Holder
Courtesy of GENERAL MOTORS COMPANY
Loosen the 6 automatic transmission flex plate bolts.
Remove the EN-652 holder (1).
Remove the 6 automatic transmission flex plate bolts (2).

Fig 2: Automatic Transmission Flex Plate And Bolts
Courtesy of GENERAL MOTORS COMPANY
Remove the automatic transmission flex plate (1).