Automatic Transmission Flex Plate Installation

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-652 Automatic Transmission Flex Plate Holder

For equivalent regional tools, refer to Special Tools .

Clean the automatic transmission flex plate bolt threads.
Install the automatic transmission flex plate (2) and the EN-652 holder to hold the automatic transmission flex plate (2).

Fig 1: Automatic Transmission Flex Plate And Holder
Courtesy of GENERAL MOTORS COMPANY
Install the 6 NEW automatic transmission flex plate bolts (2) and tighten the bolts to 60 N.m (44 lb ft).

Fig 2: Automatic Transmission Flex Plate And Bolts
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Remove the EN-652 holder.