Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify the scan tool Reverse Position Switch parameter is Off with the transmission in Neutral and changes to On when the transmission is shifted into reverse.
- If the parameter does not change from Off to On
  Refer to Circuit/System Testing .
- If the parameter changes from Off to On
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.