LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - M32) >> Diagnostic Information and Procedures >> DTC P0812: Reverse Position Switch Circuit >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the B16 Backup Lamp Switch.
  2. Test for less than 5 Ω between the ground circuit terminal 2 and ground.
    • If 5 Ω or greater 
    1. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 5 Ω 
  3. Ignition ON.
  4. Verify the scan tool Reverse Position Switch parameter is Off.
    • If the parameter is not Off 
    1. Disconnect the X3 harness connector at the K20 Engine Control Module.
    2. Test for infinite resistance between the signal circuit terminal 1 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K20 Engine Control Module.
    • If the parameter is OFF 
  5. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal 1 at the B16 Backup Lamp Switch harness connector and ground.
  6. Verify the scan tool Reverse Position Switch parameter is On.
    • If the parameter is not On 
    1. Disconnect the X3 harness connector at the K20 Engine Control Module.
    2. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K20 Engine Control Module.
    • If the parameter is On 
  7. Test or replace the B16 Backup Lamp Switch.
scientia non olet · About LEMON Manuals