Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the front right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
- Install the EN-913-A wrench to the tensioner bolt (3).
- Rotate the tensioner clockwise, using the EN-913-A wrench in order to release the tension from the generator, air conditioning compressor and power steering pump belt and to insert the EN-6130 holding pin (2).
- Remove the EN-913-A wrench.
- Remove the generator, air conditioning compressor and power steering pump belt (1).