LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LUZ) Diesel) >> Repair Instructions - On Vehicle >> Engine Oil Heater Power Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the front compartment insulator. Refer to Front Compartment Insulator Replacement .
  4. Remove the 3 mount wire tie clips (1).
    Fig 1: Engine Oil Heater Power Cable Plug And Engine Oil Heater
    GM3221568Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the engine oil heater power cable plug (2) from the engine oil heater (3).
  6. Lower the vehicle.
  7. Loosen the engine oil heater power cable (1). Loosen the retainers.
    Fig 2: Engine Oil Heater Power Cable
    GM3221569Courtesy of GENERAL MOTORS COMPANY
  8. Remove the mount wire tie clip (2) from the bracket (1).
    Fig 3: Mount Wire Tie Clip And Bracket
    GM3221567Courtesy of GENERAL MOTORS COMPANY
  9. Unclip the retainers (4).
  10. Remove the engine oil heater power cable (3).
  11. Transfer the mount wire tie clips and retainers as necessary.
    NOTE: Mark the original mounting position of the mount wire tie clips and the retainers.
scientia non olet · About LEMON Manuals