LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LUZ) Diesel) >> Repair Instructions - On Vehicle >> Crankshaft Sprocket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Open the hood.
  2. Remove the timing belt. Refer to Timing Belt Replacement (New Belt)  and Timing Belt Replacement (Used Belt) .
  3. Install the EN-47630  holder (1) in combination with EN-956-1  extension (2) to the crankshaft sprocket.
    Fig 1: Holder And Crankshaft Sprocket
    GM2190609Courtesy of GENERAL MOTORS COMPANY
  4. Remove the crankshaft sprocket bolt (3) and the spacer (2).
    Fig 2: Crankshaft Sprocket Bolt And Spacer
    GM2190621Courtesy of GENERAL MOTORS COMPANY
    NOTE: The bolt has left hand thread.
  5. Remove the crankshaft sprocket (1) with the EN-47630  holder.
scientia non olet · About LEMON Manuals