Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve Splash Shield Installation

WARNING: This page is about a different variant/trim than selected.

Install the turbocharger wastegate actuator vacuum control solenoid valve splash shield (2).

Fig 1: Splash Shield Bolts And Nut
Courtesy of GENERAL MOTORS COMPANY
Install the 3 splash shield bolts (1) and tighten to 9 N.m (80 lb in).
CAUTION: Refer to Fastener Caution .
Install the turbocharger wastegate actuator vacuum control solenoid valve splash shield nut (3) and tighten to 9 N.m (80 lb in).