LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LUZ) Diesel) >> Repair Instructions - Off Vehicle >> Exhaust Gas Recirculation Valve Installation

Exhaust Gas Recirculation Valve Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean all sealing surfaces.
  2. Install the closing plate (1).
    Fig 1: Exhaust Gas Recirculation Valve And Bolts
    GM2191217Courtesy of GENERAL MOTORS COMPANY
  3. Install the 4 closing plate bolts (2) and tighten in two passes:
    CAUTION: Refer to Fastener Caution .
    1. First pass to 3.5 N.m (31 lb in).
    2. Final pass to an additional 10 N.m (89 lb in).
  4. Install the exhaust gas recirculation valve flat washer (5).
  5. Install the exhaust gas recirculation valve (3).
  6. Install the 2 exhaust gas recirculation valve bolts (4) and tighten in two passes:
    1. First pass to 6 N.m (53 lb in).
    2. Final pass to an additional 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals