LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LUZ) Diesel) >> Diagnostic Information and Procedures >> DTC P06DA-P06DC: Engine Oil Pressure Control Solenoid Valve Control Circuit >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.

Static Test

  1. Ignition OFF, disconnect the harness connector at the Q44 Engine Oil Pressure Control Solenoid Valve.
  2. Test for 10-30 Ω between the control terminal 2 and the ignition voltage terminal 1.
    • If not between 10.0-30.0 Ω 

      Replace the Q44 Engine Oil Pressure Control Solenoid Valve.

    • If between 10.0-30.0 Ω 
  3. Test for infinite resistance between each terminal and the Q44 Engine Oil Pressure Control Solenoid Valve housing.
    • If not OL 

      Replace the Q44 Engine Oil Pressure Control Solenoid Valve.

    • If OL 
  4. All OK.
scientia non olet · About LEMON Manuals